Buehler鑲嵌機SimpliMet  3000型產品特點：

可編程性降低復雜性

· 適用于有多種鑲嵌樣需求且鑲嵌尺寸不同的實驗室。

· 存儲和撤銷5種不同的程序，降低復雜性和消除錯誤， 提供靈活性來滿足多變的實驗室要求

通過選擇不同尺寸的模具來優化各種各樣的試樣大小。節約鑲嵌介質并提升鑲嵌質量

Specifications
Operation	Automatic electro-hydraulic
Power Source	85-264VAC, 50/60Hz, 1 phase
Molding Pressure	1200 - 4400psi [80 - 300bar] in 100psi [5bar] increments
Molding Temperature	120 - 360°F [50 - 80°C] in 20°F [10°C] increments
Heating Power	1500Watt @ 115/230VAC
Heating Time	0 - 20 minutes in 10 second increments
Cooling Time	0 - 30 minutes in 10 second increments
Mold Type	Cylindrical, including upper and lower rams and duplex mold spacer
Closure Type	Insluated bayonet with piston indent
Mold Diameters	1in, 1.25in, 1.5in, 2in, 25mm, 30mm, 40mm, 50mm
Touch-pad Controls	On/Off; Heat Time; Cool Time; Molding Temperature; Molding Pressure; Mold Size; Ram Up/Down; Maunal Cool; Cycle Start; Cylinder Open; Unit of Measure; Language and also including Thermoplastic; Load and Save Methods
Units of Measure	Imperial or Metric
Water Flow Rate	0.5gal/min [2?/min] minimum
Water Pressure	45-75psi [3-5bar]
Control Voltage	24VDC
Method Programmability	4 Buehler, Preprogrammed Methods per mold size; 25 User Definable Methods
Preload Pressure	0 - 400psi [0 - 30bar] in 50psi [5bar] increments
Thermoplastic Function	Automatically sets correct parameters for thermoplastic resins such as TransOptic? and cools the mount in a controlled, linear fashion
Compliance	In accordance with EC Directives